KRYPTVIEW UPDATE HELP
4 posters
:: Kryptview
Page 1 of 1
KRYPTVIEW UPDATE HELP
Hi there just got me old kryptview A78 out loft set it up see if it still worked all the free view channels work but the pv dont does it still update firmware via Ethernet on the box the software that is on it is pv4.1.05 v3.0.0 or do i need to flash it via cable on the pc any help please
harpo1- Learning
- Number of posts : 30
Registration date : 2012-10-13
Re: KRYPTVIEW UPDATE HELP
Firmware is out-of-date latest is 16/08/13
Try to update via remote Menu-Password=0000-SW Update, if that don't work update the latest in downloads via cable, then use remote to update to 16/08/14 firmware.
Try to update via remote Menu-Password=0000-SW Update, if that don't work update the latest in downloads via cable, then use remote to update to 16/08/14 firmware.
Last edited by jonpc on Tue Apr 15 2014, 23:38; edited 1 time in total (Reason for editing : Wrong date)
jonpc- .
- Number of posts : 2835
Registration date : 2008-08-11
Re: KRYPTVIEW UPDATE HELP
cheers jonpc give it a go mate thanks alot matey
harpo1- Learning
- Number of posts : 30
Registration date : 2012-10-13
Re: KRYPTVIEW UPDATE HELP
jon that should be 16813 not 14 unlees you can see into the future lol
Cheers Taffy, jon's crystal ball. lol
Cheers Taffy, jon's crystal ball. lol
TAFFYD- VIP
-
Number of posts : 748
Location : north east
Registration date : 2008-11-07
Re: KRYPTVIEW UPDATE HELP
Didn't up date via internet so updated it via cable all working fine now thanks alot guys
harpo1- Learning
- Number of posts : 30
Registration date : 2012-10-13
Re: KRYPTVIEW UPDATE HELP
When I get to stb editor a message reads as follows
Can't open serial port com1
Please check if the com port has the following parameters
Baudrate :115200bps
Parity:no parity
DATA byte :8bit/data stop bit: 1
What am I doing wrong could someone please explain to me thank you
Can't open serial port com1
Please check if the com port has the following parameters
Baudrate :115200bps
Parity:no parity
DATA byte :8bit/data stop bit: 1
What am I doing wrong could someone please explain to me thank you
paulyboy- Number of posts : 5
Registration date : 2014-03-29
:: Kryptview
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|