Diseq Problem
2 posters
Page 1 of 1
Diseq Problem
I was wondering whether anyone else had seen this problem.
Firstly my configuration , I have a 1.65m dish aimed at Astra 2 (28.2East), In addition I have a a second 1.2 metre dish aimed at astra 1 19 Degrees east.
I am using a 4 port diseq switch, of which I am only using the first two ports.
I have setup up the diseq settings in the menu and can view the channels from both satellites.
When I change from a channel that is on Astra 1 to a channel that is on astra 2 all is well and the channels display ok. But when I do the opposite change from astra 1 back to astra 2 all channels display 'no signal being received' is displayed. At this point if I put the box into stanby, then back on again channels are ok.
This problem is especially annoying if I use the 'group' option because I only want to view HD channels.
any Ideas, Thanks in advance
Regards Colin
Firstly my configuration , I have a 1.65m dish aimed at Astra 2 (28.2East), In addition I have a a second 1.2 metre dish aimed at astra 1 19 Degrees east.
I am using a 4 port diseq switch, of which I am only using the first two ports.
I have setup up the diseq settings in the menu and can view the channels from both satellites.
When I change from a channel that is on Astra 1 to a channel that is on astra 2 all is well and the channels display ok. But when I do the opposite change from astra 1 back to astra 2 all channels display 'no signal being received' is displayed. At this point if I put the box into stanby, then back on again channels are ok.
This problem is especially annoying if I use the 'group' option because I only want to view HD channels.
any Ideas, Thanks in advance
Regards Colin
coolsolutions- Newbie
- Number of posts : 12
Age : 54
Location : Almeria Spain
Registration date : 2011-08-03
Re: Diseq Problem
What about trying it with usals settings.
jonpc- .
- Number of posts : 2835
Registration date : 2008-08-11
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|