[solved]kryptview - transponder problem

my kryptview box only picks up 1 transponder after a factory reset.
i do auto search on ex-cw and select network from the menu. but when i press
the green button for start search it pick up only 1 transponder. i keep pressing
the red button to search all network but it just wont find any.

is my box dead? is there a way around this?

thanks rgds
fib

ok after reading up on it. for auto search i have to select network id. the problem
is my box doesn't have any list. it keeps saying searching for network and then says complete
please wait. when i exit, the easy installation menu pop up and i agian select auto search.
the box is stuck in this loop.

any way to fix this.


rgds fib

what firmware is on box and what model do you have,also do you have a live feed.

morehelpme wrote:what firmware is on box and what model do you have,also do you have a live feed.

Hi, the box is A780 with may/2010 firmware. it was working and moved it to another room, the channels
disappeared. so i did a scan, no luck. so i did factory reset and that swhen the problem started.
i flashed the box with latest firmware still no good. i reflashed with the original firmware, still no net-id
to choose from for scanning.

tks
rgds fib

is there a chance cable is in wrong position?

morehelpme wrote:is there a chance cable is in wrong position?

thats the first thing i checked. all connections are as they should be.
i'm just no getting the screen with list of networks to choose from.

rgds fib

sounds as if you have a bad cable.

Take it back to the room where it worked,also install the latest firmware June https://dooby2oons.forumotion.com/kryptview-f18/new-firmware-18-0610-t2007.htm
If using box in another room "home plugs "may be your best option.
Presume your area has gone to Nag 3

did you have 2 subs upstairs and downstairs and now have 1 downstairs
as you can get 2 signal levels because of 1 not used.

morehelpme wrote:did you have 2 subs upstairs and downstairs and now have 1 downstairs
as you can get 2 signal levels because of 1 not used.

thanks folks.

i finally sorted this out. my box never gave option of choosing network id/area.
i didn't give up.
here's what i did:- press menu. select user preference. enter pin. select sat/tp option.

when in sat/tp screen, i selected my area, ex-cw, and pressed right arrrow button.
which brought up list of trandponders assigned to my ex-cw.
in my case there was just one tp. so i deleted it and still in prefernce menu, i selected delete
all channels.

went back into auto search and selected my area and network , then pressed green option for search.
on pressing green i pressed the red button. the box started a proper search and picked up 140
transeponders and all the corresponding channels, about 460.

so the box is up and running



i hope this helps others in same situation.

thanlks again folks, for the effort and support.

rgds
fib

always nice to see a post where someone has managed to sort there box probs out and shared the fix with everyone else im getting a kv780 soon and if i should have transponder prbs know where to find the help needed to get it srted glad yr up and running m8

well done also report back for others what you think of it.