wi fi bridge
5 posters
Page 1 of 1
wi fi bridge
can i use a wi fi bridge with the blade 7000s
jamesmcz11- Newbie
- Number of posts : 18
Registration date : 2011-10-14
Re: wi fi bridge
Yea, I used the WN200RPT. 30 quid from ebay.
Its a 'N' bridge as well.
2 mins to set up then just plug in the ethernet cable.
Your good to go.
Its a 'N' bridge as well.
2 mins to set up then just plug in the ethernet cable.
Your good to go.
Paddy_- Learning
-
Number of posts : 49
Age : 38
Registration date : 2011-10-01
Re: wi fi bridge
On that note the Vonet VAP11 wireless bridge also works fine.
isoul786- Number of posts : 2
Registration date : 2011-07-16
Re: wi fi bridge
You can also use a tenda w150m wifi bridge £18.99 from world of satellite
adebev- Number of posts : 5
Registration date : 2011-10-24
Re: wi fi bridge
I'm using a Vonet VAP11G with my Netgear DG834GT and constantly been disconnected, works fine for hours then refuses to connect, always happens toward the end of a movie! If I check the IP settings sometimes it seems to have dumped them and if I power of/on it doesn't seems to take them again unless its left off for abit other times it wil have changed the IP address. Would manually entering connection settings rather than using DHCP solve this or could it be faulty hardware?
The range shouldn't be an issue it's only a stud wall/door and around 4m.
The range shouldn't be an issue it's only a stud wall/door and around 4m.
ST Kyle- Number of posts : 1
Registration date : 2011-11-04
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|